BM F 750/850 GS LED - Fog lamps with MotoBozzo-Switch-2 electronic control via mini push button
.jpg)
Mountable above and below!
.jpg)
Here the new LED fog light set on the BMW F 750/850 GS in quick assembly technology. As a holder serve here Stainless steel brackets, which are easily screwed to existing panel holes.
Can be mounted at the top or bottom, if a possibly mounted crash bar should be in the way.
The supplied wiring harness is custom-fit and completely prefabricated to simplify installation - see photo. The special accessory connector prepared by BMW can be found at the top right above the speedometer. These are plugged in our BMW cable plug, done. Thus, no further cables are connected to the F 750 GS!
No further soldering or botched current thieves / cable branches, no connection to the battery / flying fuse required!
It is switched by MotoBozzo-Switch-2 electronics - this is controlled by a mini pushbutton, which can be stick with 3M adhesive pad super-strong individual. Thus, can be switched at any time without having to take your hands off the handlebar when the button is mounted as in the example photo.
No relay, it is switched directly electronically!
Only dimmed headlights with LED lamps on
-1.jpg)
Data LED projector lamp:
Power / Power 12V: 6W
Power Consumption / Consumption 12V: 0.5A
LEDs u. Type 1 piece Osram OBF LED
Fastening Points / Fastening Points 2 M6
Approval ECE, SAE, EMC
Ventilation / Ventilation Membrane
Material Housing Aluminum / Alloy
Material Front Lens PC hardened / hard coated
Temperature range / operation range -40 - + 80 ° c
Protection Class / IP Classification IP6K9K / IP68
• Aluminum housing, black powder-coated and structured
• Corrosion protection for 480h salt spray
• extremely compact design
• ECE, SAE, EMC approved
New generation 70mm LED fog light with integrated control unit. With only 6 watts of power consumption super bright, additional wiring harnesses for an external controller will fall away. Nitto Denko Air Cap ventilation. Clear light / dark border and concentrated illumination without light scattering.
Very small installation depth (55mm).
Function MotoBozzo Switch 2 Electronics:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off or switched on again by briefly pressing the mini push button.
If it is desired that the lights are turned off after starting, unplug the purple wire and instead clamp the prepared green wire.
The connectors are shrunk with adhesive shrink tubing against moisture, this must be removed and then replaced!
Regardless of which switching state was last selected, the lamps always switch on when they are switched on (delivery status purple wire inserted), thus forcing in forgetting is excluded. This can be changed by switching, then the lamps are always after switching on the ignition
first switched off (optionally repluggable, green wire).
These lights, switched on by day, increase their safety, because you are much better seen as a motorcyclist!
Registration as LED foglamps provided with E-mark!
Delivery:
2 Stainless steel brackets with 2 LED fog lamps, pre-assembled
1 wiring harness, MotoBozzo-Switch-2, mini push button and BMW plug, pre-assembled
1 illustrated assembly instructions