R 1200 RS-LC 2019 LED- Fog/driving lamps

BMW S 1000 XR LED-foglightset including MotoBozzo switch.

Here you can see the mounted LED-lightset on the BMW S 1000 XR with 2 VA brackets, black plastic coated, which can be easily mounted on existing screws on the fairing. Longer new screws are included, a rubber strip protects the brackets against scratching.
The lamp cables can be laid either by supplied mini adhesive pads or cable grommet and hole (see photo). These fog-/daylights optimally support the existing headlights.
The 3 Power LEDs ensure a very good light output with a current consumption of only 0,6 Ampere (7,5 Watt) at 12,5 Volt, 160 Lumens the lamps are E-marked.
The wiring harness is prefabricated to simplify installation.
The two LED-foglamps create almost 120 degrees of illumination.
Switching with your existing light-horn button, so it can be switched at any time without having to remove the hands from the handlebar.
Only one MotoBozzo-Switch control wire is connected to the ignition positive pole at your On-board electrical outlet. The second control wire connect to the highbeam + pole. Two wires go to the battery (plus and minus pole), so the lamps work completely independently without disturbing the CanBus system

Function MotoBozzo-Switch electronic:

When the ignition is switched on, the lamps switch on automatically.
Now the lamps can be switched off or switched on again by 2 x short press the lighthorn/pass-button (click-click).
The operating status is indicated by a green LED.
After the ignition is switched off, the lamps still light up for approx. 60 seconds, if you don't want this, simply switch off by double-clicking.
If it is desired that the lamps are switched off after starting, simply pull off the purple wire and instead clamp the prepared green wire.

These lights, switched on by day, increase your safety, you are seen as a motorcyclist much better!



Delivery:

2 plastic coated VA holders including 2 pieces of LED-driving/foglamps (apiece 7,5 Watt total 15 Watt by 12,5 Volt)
1 wiring harness with relay, MotoBozzo-switch electronics and separate fuse (all pre-wired)
1 illustrated mounting instruction