MotoBozzo-Switch-2 Universal Harness
The wiring harness is prefabricated and requires only one ignition plus and 12V battery voltage. To use fully on all motorbikes / motorcycles, any consumers up to 15 A, LED or halogen lights can be switched.
Mini button waterproof:

Function of the MotoBozzo-Switch-2 electronics with Minipush button:
The MotoBozzo-Switch-2 is a small electronics that uses a mini pushbutton to turn on / off the headlamps / consumers.
The electronics are sealed watertight and are switched by a waterproof mini push button, regardless of the last switching state!
The system works completely independently, without affecting the CanBus system (if available)!
After the engine is started, the MotoBozzo-Switch 2 electronics automatically switches on the lamps / consumers first, and automatically switches them off again when the ignition is switched off, so no further switching is necessary.
The lamps / consumers are now switched by push button of the mini push button. The mini button is connected to the electronics via connector, he is very small and can be attached individually everywhere by adhesive adhesive pad, see sample photos.
If you do not want the lamps / consumers to switch on automatically after starting the engine, you can reverse the polarity by replacing prepared cables. Now, however, must be switched on after clicking each time by clicking. I find this feature rather annoying, and it runs the risk of forgetting to turn it on ;-)
A green LED indicates the operating status of the lamps, the LED cable can be extended or shortened as desired.
Delivery:
MotoBozzo-Switch 2 with mini button, relay 40 A, battery cable with fuse 15 A all cables pre-wired (see example photo).
All main power cables are covered with additional protective hose for safety!
.jpg)